Release time：2023-12-20 10:54:38
Today, the development status of the briquetting machine industry is significantly better than in previous years. China's economy is in a critical period of transitioning from a growth stage to seeking a new balance. Regarding the current development status of briquetting machine equipment, Zhengzhou Shisheng Machinery Equipment Factory said that the equipment is in the growth stage. Although the technology and structure are stable, there is still a long way to go before high-end technology. Therefore, Shisheng briquetting machine Machinery equipment manufacturers are still very thirsty for cutting-edge technology.
With the breakthrough of technical difficulties, the pulverized coal briquetting machine can press pulverized coal into pellets at one time, with high output and high hardness. It can press powdery or granular pulverized coal into spherical, oval, and flat shapes through strong pressure. Round and other shapes, the pulverized coal pressed by the pulverized coal briquetting machine can be used in blast furnace smelting, metal reduction and other fields. This project is a good project for energy conservation and resource reuse. It is encouraged by and policies, and at the same time it can obtain tax revenue The preferential policies create huge benefits.
The strength of the finished ball is too small. How to solve the problem of insufficient strength of the pressed ball during production?
The pulverized coal briquetting machine adjusts the dry humidity and feeding amount of the material, and adjusts the roller gap. The method for adjusting the roll gap is: use a movable plate or pipe wrench to twist the downward pressure screw on the inclined iron clockwise to move the auxiliary roll inward to achieve the purpose of adjustment. If the lower screw rod cannot be tightened, open the front and rear plugs of the main machine, open the bolts connecting the vertical support plate and the upper beam, use a pry bar to pry the slant iron inward, and then twist the lower rod clockwise to check the rollers. After the gap is appropriate, tighten the bolts connecting the vertical support plate and the upper beam, and replace the plug.
The finished ball is misaligned. How to solve the problem of finished ball misalignment?
The fastening bolts on the auxiliary roller gear adjustment plate should be loosened, and the jackscrew should be used to push the gear away from the adjustment plate so that the roller can move. The purpose of turning the gear inward is to eliminate the gear gap and push out the jackscrew. Then turn the passive roller to align the ball socket. When doing this work, you should pay attention to that when aligning the ball socket, the ball socket of the auxiliary roller is 1-2mm lower than the main roller socket. Then tighten the fasteners on the 1-2mm adjustment plate. Bolt, turn the gear in the positive direction, and check whether the ball sockets of the two rollers of the decoal pulverized briquette machine are aligned. If not, loosen the fastening bolts and readjust them until all the fastening bolts are tightened after alignment.
