Why is the flap dryer called a flap, because the flap running in the box walks to the head or tail of the machine, and it will automatically turn over, that is, it will run back and forth twice on the same floor, while the mesh belt dryer Only run once. If they are all four-layer dryers, the flaps of the flap dryer run and dry eight times in the box, while the mesh belt of the mesh belt dryer only runs and dries four times in the box. The drying efficiency of the dryer is better than that of the mesh belt dryer.
2. The Chain Sheet Dryer Occupies a Small Area
Because the drying efficiency of the flap dryer is good and the drying area is large, therefore, under the condition of the same output, the length of the flap dryer is shorter than that of the mesh belt dryer, which saves the workshop area.
3. The Breakage Rate of the Chain Sheet Dryer is Low
The flap dryer produced by our company is a small flap, and the up and down height of each flap is only 200mm, and the flap is turned down by the track, so the materials inside also slowly fall to the next layer, basically There is no damage on it.
The drop height of the mesh belt dryer is 400mm, and it will be a little damaged if it is dropped.
The height of the vertical dryer is 7.5m. At the beginning, the material will be damaged greatly, and it will basically be broken. Only when the cylinder is filled, the damage will be small. However, there are many materials in the cylinder, and the friction between them will also cause damaged.
4. The Chain Sheet Dryer Runs Smoothly and the Chain Sheet Does not Sink
The operation of the flap is to run in the track in the box, and there are rollers on the flap to ensure the stable operation of the flap. The flap is stamped from a whole steel plate, which bears high pressure, and the material will not deform or sink when it is laid flat on it.
When the mesh belt is running, materials are paved, and the materials are easily concentrated in the middle of the mesh belt, so that the mesh belt will form a mesh pocket, causing the mesh belt to sink, causing the mesh belt to rub against the lower rollers, etc., causing the mesh belt to break.
5. The Chain Sheet Dryer Automatically Cleans Up Leftover Materials
The flap dryer is equipped with an automatic cleaning bulk material device below, which does not need manual cleaning like the mesh belt dryer.
